
-
Tongue & Groove V-Notch Set
- Reviews
2 flute, carbide tipped. Item #7843 comes with fully enclosed ball bearing guide. This set is a 2 bit system for producing interlocking tongue & groove with a V-groove on the face. Excellent for paneling or flooring. A fence is required. Cuts 1/4" high x 3/8" deep tongue and groove.
Tongue & Groove Instructions(PDF)
Tongue and Groove V-Notch Set | |||
---|---|---|---|
Item | Shank Size |
Price | |
#7843 | 1/2" | $74.95 | ![]() |


all customer reviews and ratings
Average Customer Rating: (2 reviews)
Add your own review for this product

By Robert Moffa (Jasper Ge US)
I purchased this T&G set for a large kitchen island project. I covered three sides of the island base with random-width T&G cherry vertical planks. The end result was great, but...
There are two things I don't like about this set. I tested the bits when they arrived on some soft pine scrap I had laying around the shop. The first problem for me is the guide bearings do not ride on the stock. They are only useful in aligning the router table's fence. This seems to be a trend and I see no advantage to it. The second issue is the fit. It seemed fine when I tested with soft pine, but with cherry is was a different matter. It was extremely difficult to even get my short test pieces together and almost impossible with my three-foot planks. Fortunately, I have a large (1") cove bit that allowed me to tapper the tongues a little bit so the planks would slide together more easily. A two-piece groove bit with adjustment shims would have been greatly appreciated.

By Jeffrey Alexander (Pendleton IN US)
Nice and sharp, excellent fitting for a matched bit set. Cut really well on my cedar breadboard wall panel project. I was impressed with this matched set!