"Cabinet capability in a box"

Selected excerpts of a review by Tom Hintz that appeared on NewWoodworker.com

All of the MLCS 6-Piece Pro Cabinetmaker Bit Set bits made clean precise cuts right out of the box. Setup of all of the included profiles was easy and quickly confirmed with test cuts. Even the matched rail and stile bits cut a perfect fitting joint so I did not have to even open the included shim pack. I like a rail and stile joint to go together easily so that it accepts glue without having to increase pressure to close it fully. The MLCS matched set was adjusted perfectly at the factory for that fit...

The panel raising bit with undercutter produces a very clean, consistent thickness edge. I also found that edge to be properly sized for the groove cut by the rail and stile set. That gives the panel a nice floating fit within the rails and stiles that will not inhibit expansion/contraction cycles...

Despite the economical price the 6-Piece Pro Cabinetmaker Bit Set uses C2 carbide for the cutting edges...

The MLCS 6-Piece Pro Cabinetmaker Bit Set comes with a nice wooden box for storing the bits when not in use."

MLCS_dovetail_jig_review

The MLCS Cabinetmaker Bit Set comes with a handy shim pack that includes a bunch of shims along with extra lock washers and nuts for the bits. These shims are intended for adjusting the fit of the rail and stile joint...

For the full review and photos go to NewWoodworker.com